Power driven uncoilers Flippers Passive turntables Power assisted turntables

Large diameter feeders Double passive turntables

Power Driven Uncoiler for Wire or Rod

• Designed for todays high speed heavy coil applications
• Twin support mandrels reduce coil sway allowing faster speeds (8”)
• Pneumatically actuated feed rolls 8 or 12 inch diameter
• Portable operator station
• End of coil detector
• Rugged “I” beam construction to support the largest coils
• 90 inch long mandrels
• Snag detector switch
• PLC controlled machine operation
• Electronic variable frequency drive to control speed
• Options include full enclosure, cutoff saw, single or double plane straighteners.

Model 890 double 8” mandrel model. 1” (25mm) capacity

Model 1296 uncoiler. 1.5” (38 mm) capacity

Optional cut off saw with coolant tank

Back to top

Rod Flipper

Both large diameter and Small diameter saddle.

• Allows for coil changes without stopping the production line
• Suitable for coil sizes up to 6000 pounds
• Use rod sizes from .218 to .640
• Use coils with an un-banded width of up to 7 feet
• Available in "Z" or "S" configurations

Back to top

Passive Turntables

• 30 to 70 inch top plates
• Up to 7000 pund capacity
• Air or mechanical drag brakes
• Wire containment "snag" ring
• Powered units available

Back to top

Power Driven Turntables

• 5 hp variable frequency drive with dynamic braking
• Adjustable tension, spring loaded dancer arm
• Adjustable height dancer arm roller assembly
• 50 or 60 inch diameter top plate
• 5000 pound coil capacity
• Wire containment ring
• E-stop, snag detector, and production machine interlocks
• Power disconnect switch
• Reversible rotation, via selector switch
• 0 to 45 rpm speed range std, others available
• Standard with 1 outboard coil lifter arm and 3 mounting pads. (shown with 3 outrigger arms)
• Exclusive speed control system, either full "dancer arm authority" or "Master speed setting with dancer arm trim"
• Controls conveniently placed on electrical cabinet

Back to top

Large Diameter Feeder

1” capacity 8” feed roll unit shown with optional track system.

• Eliminate the danger of operator injuries cause by pulling the end of the coil out by hand
• Pull the End form a coil using a simple winch system
• Run at any speed, with tangle free operation
• Available with track assembly to power the unit out of the wire line
• Air actuated feed head with 8-inch rolls
• Units available for material up to 1.5 inch diameter

¾” capacity 6” feed roll unit shown with optional track system

Back to top

Double Passive Turntables

· Quicker coil changes

· Stand-by coil is pivoted into position when active coil is depleated.

Back to top

Main - Machinery - Wire Drawing – Concrete Pipe - Payoff - Parts & Tooling – Services - News – Literature - Contact